HP 9000 300 Series Hardware Configuration Manual page 65

5
5. You would install the new 4 Mbyte boards in
RAM PAIR 1
slots
6. When you turned on your controller, the amount of RAM listed would be
about 16 776 916 bytes.
Example: Upgrading 8 Mbytes to 24 Mbytes
To upgrade a Model 382 Controller with 8 Mbytes (two 4 Mbyte RAM boards)
to 24 Mbytes with the HP A2202 16 Mbytes Board Set, you would follow these
steps:
1. The amount of RAM existing is 8 Mbytes. You would write that amount in
Table 5-2's 'Existing, Total' block as the example shows below.
Example Existing Memory ys. Upgraded Memory
Total
RAM PAIR 0
RAM PAIR 1
Existing 8 MB
Upgraded
2. Refer to your controller/controller's memory and determine the size of the
RAM boards already in the slots. One of these configurations in Table 5-3
will exist.
Model 382: RAM Board Configurations for 8 Mbytes
Total
Memory
RAM PAIR 0 RAM PAIR 1
8 MBytes
[4
MBl
[4
MBl
8 MBytes
[2 MB)[2 MBl
[2 MB)(2 MBl
If two slots have boards, the boards are 4 Mbytes. This condition is used in
this example.
You would write '4 MB' in Table 5-2's 'Existing' block for 'RAM PAIR 0
shown below:
5-16 Memory Configurations