Verification Test; Filling Out The Worksheets - HP 9000 300 Series Hardware Configuration Manual

Reinstalling the High-Speed HP-IB Card
Insert the high-speed HP-IB card, component side up, into its slot. Tighten the
thumb screws on the metal end plate until the end plate is flush with the back
of the controller.
Verification Test
1. Plug in your controller's power cord and video cable, then turn on your
moni tor and controller.
2. When the keyboard line appears, press
(space
bar)
a few times to go into
attended mode.
3. Check the interfaces listed on the left-hand side of the screen:
• If the message,
HP98625,
is listed, you have correctly installed the HP-IB
Interface .
• If the message above does not appear, check the installation procedure
and configuration settings, making sure there are no select code conflicts
and that the card is firmly seated in an even-numbered slot. If the
message still does not appear, call your HP Service Representative for
assistance.
Filling Out the Worksheets
The following "Worksheet Entries" contain information needed to use the
high-speed HP-IB interface with various language/operating systems. Refer to
the table for the system you'll be using.
Copy this information to a worksheet found later in this section and remember
to refer here when you need it. If you changed the select code, write in your
new select code instead of 14.
When finished, you'll be ready to install your next peripheral or interface.
Configuring Popular Accessory Cards 10-21
10