Replacing The Battery - ViewSonic PJD5112 User Manual

Replacing the Battery

For the first time use:
Remove the transparent insulation tape by pulling
it before use.
For battery change:
1. Push the catch to the left and remove the battery
holder.
2. Remove the old Lithium coin cell and install new one
(CR2025). Ensure that the side with the mark "+" is up.
3. Push the battery holder back into the remote control
until you feel a click.
Caution
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Make sure the plus and minus terminals are correctly aligned when loading a battery.
EN-12
Keep the battery out of the reach of children.
Do not recharge the battery or expose the battery to fire or water.
Do not dispose the used battery along with household waste. Dispose u
batteries according to local regulations.
Danger of explosion may happen if batteries are incorrectly replaced.
Replace only with the same type recommended by the manufacturer.
Battery should not be in or near to fire or water, keep batteries in a dark
and dry place.
If suspect battery leakage, wipe out the leakage and then replace a new bat
the leakage adheres to your body or clothes, rinse well with water immediat