On/Off Control; Speed Adjustment - RIDGID RS-570 Operator's Manual

Figure 8 – Centering Pin Engagement with Blade
5. Tighten the screw firmly and insure the
blade is securely fastened by the clamp.
6. Return the hex wrench to the holder on the
saw cord.

ON/OFF Control

Hold the reciprocating saw firmly by the handles
to reduce the risk of shock. Make sure the blade
is not in contact with anything.
Assume a proper operating position. Do not
overreach. Keep proper footing and balance at
all times. A proper operating position enables
better control of the tool in unexpected situations.
Selector No load speed
Position (Strokes/Minute)
A
B
C
D
E
F
G
Figure 11 – Speed Table (
999-995-148.08_REV. B
Metal
•
700
•
950
•
1200
1500 –
1750 –
2050 –
2200 –
•
Suggested For Application)
RS-570 Reciprocating Saw
Actuate switch with two steps as shown in Fig-
ure 9.
1. Push Foward
Figure 9 – Switch Operation
The saw is equipped with a soft-start feature.
The saw will start at low speed and gradually in-
crease to full speed after 3-4 seconds. Allow saw
to come to full speed prior to cutting.
To turn saw OFF, release the ON/OFF switch.

Speed Adjustment

The operating speed for different materials
varies depending on a variety of factors (type of
material, blade type, accessibility to the working
zone, etc.). Use the information from table (Fig-
ure 11) below as a starting guideline to choosing
the speed. Rotate the speed selector to align the
desired position (letter) with the mark ( ) (see
Figure 10). The operating speed for a specific
application can be determined through experi-
ence.
Figure 10 – Speed Adjustment
Wood Plastics
•
–
•
–
•
–
– –
– –
•
–
•
–
2. Pull Up
Ceramics, Aerated
Concrete
•
•
•
•
–
–
–
9