Adjusting Picture; For Av / S-Video - ViewSonic VPW505 User Manual

ADJUSTING PICTURE

For AV / S-Video

Accessing Picture Adjustment Mode
Various picture adjustments can be set using the Picture
Adjustment OSD menu. To access the OSD menu:
1. Press the MENU +/- keys on the remote or the front con-
trol panel.
2. The first menu displayed is the PICTURE menu. Make
sure that the "Picture" OSD menu is displayed.
3. Use the MENU +/- keys to move up and down to choose
the option you wish to adjust. An explanation of each
adjustment is listed below.
4. Use the ADJ +/- keys to change the setting.
Notes:
These controls are avail-
able when input selection
is set to: AV1 and AV2
(S) inputs.
To restore picture settings
to the factory defaults,
simply press the RECALL
key from the remote con-
trol.
Notes:
1. Each of the (4) color temperature settings may not be exactly equal to the temperature setting as defined;
however, it will be approximately close.
CONTRAST
Adjust Contrast to increase the level of "white" in the video picture.
Increasing contrast will make white areas of the video picture
brighter. Contrast works in conjuction with BRIGHTNESS.
BRIGHTNESS
Adjust brightness to enhance the level of dark areas in the video
picture such as night scenes and shadow scenes. Increasing
brightness will make dark areas more visible.
COLOR
Use color to adjust the color saturation of the video picture.
Increasing color will make the color more intense. Reducing color
setting will make the color less intense.
TINT
Use tint to adjust the color of fleshtones. Increasing the tint setting will shift
the picture with more cyan (more green appearance). Decreasing the setting
will shift the picture with more magenta (more red appearance).
SHARPNESS
Use sharpness to adjust the amount of detail enhancement to the video
picture. Increase the setting will enhance the edges of objects in the
video picture. Decreasing the setting will reduce enhancement.
COLOR TEMPERATURE
Select the color temperature for white balance. There are four settings
to choose from: (1) 6500D - sets the white balance to 6500D; (2) LOW -
sets to 5400K; (3) MID - sets to 9300K; (4) HIGH - sets to 13800K
CLOCK PHASE
Use clock phase to fine-tune the display to perfectly synchronize the
video's signal source. This function is not applicable in this mode.
SCREEN WIDTH
Use to change various screen width modes. See page 16 for more
information.
ZOOM
Use to change various digital zoom modes. See page 16 for more
information.
ViewSonic VPW505 21