Epson SC-F3000 Series User Manual page 132

SC-F3000 Series User's Guide
Are you using a platen without a grip pad to
o
print a job that requires a large amount of
ink?
Using a lot of ink to print, such as from data that covers
the entire print area, may cause the print surface to
swell up with ink.
If something like this happens, an error as shown
below may occur and printing may be stopped, even if
the T-shirt is correctly loaded before printing starts.
Printing has stopped.
The print head may strike the media.
If a T-shirt is loaded using a frame, removing the frame
may allow any wrinkles or slack in the printed surface
to spread to the outer edges and solve the problem.
Note that the following steps are necessary if you
remove the frame.
❏
You need to reduce the width of the White ink in
Garment Creator for SC-F3000 Series, the
software for the printer, or in the RIP software, so
that the white under-base print does not extend
outside the image.
❏
Be careful not to touch the T-shirt while printing
as it can easily move out of position.
Have you dried pre-treatment liquid
o
completely?
Printing while the pre-treatment liquid is not
sufficiently dry means the print surface may become
damp and swell up, then as you are printing, an error
as shown below may occur and printing may be
stopped.
Printing has stopped.
The print head may strike the media.
Check that the pre-treatment liquid is dry.
Cannot use the USB memory
After inserting the USB memory stick, did you
o
press ?
The USB memory is not read by just inserting the USB
memory stick. Be sure to press the
of the screen, and then do operations from the USB
printing menu.
There is a red light inside the printer
This is not a failure.
o
The light is a light inside the printer.
Problem Solver
I have forgotten the network
password
o
Emergency stop button was pressed
Confirm that everything is safe, and then use the
following procedure to release the emergency stop
button.
A
B
icon at the top
132
Contact your dealer or Epson Support.
Turn the button as you pull it out, as shown in the
illustration.
Turn the printer off, and then turn it on again.
c
Important:
After turning off the power, immediately turn
the power on again.
The print head may not be capped properly if
the printer is turned off while an error has
occurred. If it is left uncapped for a long time,
the print quality may decline, and it may be
impossible to clear clogged nozzles.