Table of Contents
Advertisement
Tap the bars down through all holes with a
hammer and a screwdriver or thin bar. Before
the bar goes all the way through the bottom
hole, thread in the locking bolt until you can
feel pressure against the mounting bar. Hold
pressure on the bar with a wrench and con-
tinue to tap the bar down until the pressure re-
leases. Then, you know that you have reached
the groove in the bar. See Photo
8/147.
Screw
the bolt all the way in without forcing. When it
reaches the bar, back off V2 turn and hold the
bolt in place with one wrench while you tighten
the jam nut with another wrench.
(Photo 8/145) Put key
&
snap ring on, then pulley.
I
Repeat the process with the bar on the other
side.
Step 3. Install the belts after referring to "Belt
Changing" in Section 7 of .this manual.
Step 4. Install the reverse disc with the mount-
ing bolt, lockwasher and plate.
PART SIX
INSTALL FORWARD/REVERSE LEVER
&
YOKE ASSEMBLY
Step 1. Remove one bolt from the base of the
Forward/Reverse Lever and tilt the lever up-
ward. Remove the clutch pawl spring (part
#1122) from one hole only. This will take ten-
sion off of the clutch roller when you are in-
stalling it-see Photo 8/148.
Step 2. Move the yoke ioto position to attach
the bolts on each side of the engine mount and
those that fasten the linkage to the retaining
plugs on the lower side. Make sure that the
bushings are inside the links before you fasten
the bolts. See Photo 8/149. If you have trouble
aligning the bolt and the hole, remove the bolt.
washer and spacer. Put them on the bolt in pro-
per order and then thread the bolt into the hole
in the motor mount. Tightening the bolt will
push the spacer into place.
(Photo 8/146) Line up holes, insert bar.
(Photo 8/147) Hold pressure on bolt and tap.
Hide quick links:
Advertisement
Table of Contents
