Coleman CO534L-A Owner's Manual page 18

16
Message
HH
OHH
Pr
SF
SL
SA
Sb
SNA
Snb
Sns
Sn
ST
Stby
Meaning
Overheat protection (spa is
shutdown). One sensor has
detected 118˚F (48˚C) at the
heater.
When your spa is fi rst actuated, it
will go into priming mode.
Safety Suction. Spa is shut down.
Indicates heater is in Sleep Mode.
Spa is shut down. The sensor that
is plugged into the sensor "A" or
"B" jack is not working.
Sensors are out of balance.
• If this is alternating with the
temperature, it may just be a
temporary condition.
• If the display shows only this
message (periodically blinking),
the spa is shut down.
Indicates heater is in Standard
Mode.
Pressing a button combination
on the user panel has activated
Standby Mode.
Coleman logo (white)
<----------
Action Required
DO NOT ENTER THE WATER!
Remove the spa cover and allow spa to cool below
107˚F (42˚C). Press any button on the topside
display to reset spa. If spa will not reset after spa has
cooled, turn off power for approximately 30 seconds
and then turn power back on. If display message is
repeated then shut the power off to the spa and call
your dealer or service organization.
The priming mode will last for up to four minutes and
then the spa will begin to heat and maintain the water
temperature in the Standard mode.
The display will show SF when a vacuum switch
closes. All functions will turn off and the system will
be disabled until a panel button is pressed.
None.
If the problem persists, contact your dealer or service
organization. (May appear temporarily in an overheat
situation and disappear when the heater cools.)
Contact your dealer or service organization.
None.
Press any button to leave Standby Mode and return to
normal operation.
Coleman Spas (online sales)
®
LTR50001135, Rev. A