Craftsman CMXETAX69434502 Instruction Manual page 14

Fig. 5
To remove/replace/align the table insert
(Fig. 6a-6b)
WARNING: The table insert must be level with the
saw table. If the table insert is too high or too low, the
workpiece can catch on the uneven edges, resulting in
binding or kickback, which could result in serious
personal injury.
WARNING: Be extremely careful your hands, avoid
to contact with the saw blade which can result in
serious personal injury when removing or replacing
the table insert.
• Lower the blade all the way to down position by turning
the height adjusting handle
• Lock the blade by turning bevel locking lever
clockwise.
To remove the table insert: Turn the lock knob
•
clockwise to unlock the table insert
nger in the hole, pulling the table insert
the front of the saw.
To reinstall the table insert: Push the table insert
•
down, turn the lock knob
the table insert in place.
Fig. 6a
2
If the table insert is not level with the saw table, using a
2.5 mm hex key (not supplied), adjust the four set screws
pre-assembled to the table located on the four holes of the
table insert until the table insert is level with the working
table.
1
3
counter-clockwise.
1
2
. Place your index
4
out toward
4
counter-clockwise to lock
3
4 3
1
Fig. 6b
2
Riving knife installation and position
(Fig.7a-7b)
CAUTION: This saw is shipped with riving knife in
"MIDDLE" position. Riving knife must be placed in
uppermost position to attach anti-kickback pawls
and blade guard for all through cut operations.
WARNING: Riving knife has three holes for three
positions. The uppermost position is for all through
cuts. The middle position is for non-through cuts (with
blade guard and anti-kickback pawls removed). The
down position is for dado cuts. (with blade guard and
anti-kickback pawls removed).
• Turn saw off and unplug saw.
To place riving knife in uppermost position (for
3
through cuts)
• Remove the table insert.
• Set the saw blade angle to 0°.
• Raise the saw blade to the uppermost position by
4
turning the height adjusting handle
• Lock the blade by turning bevel locking lever
clockwise.
• Unlock riving knife lock knob
• Grasp the riving knife
saw to release it from spring-loaded locking pin.
• Position the riving knife in the uppermost position with
spring-loaded locking pin re-engaged.
• Lock the riving knife lock knob
clockwise.
• Reinstall the table insert.
WARNING: Be extremely careful when adjusting the
riving knife position. Do not contact blade.
5
ENGLISH
5
clockwise.
1
2
by turning it clockwise.
3
and pull toward right side of
4
by turning it counter-
3
13