Advertisement
Double frame capping section
Plastic
cover strip
Installation information
The joints between two unit cubes are covered, as far as possible, with a
double frame capping section. In some instances, however, double frame
capping sections cannot be used for design reasons. In these cases, single
frame capping sections are used and the gap remaining on all sides, is covered
with a plastic cover strip or a plastic sealing section.
A sufficient number of parts of the appropriate dimensions, required for the
assembly (double frame capping section, plastic sealing strip, plastic sealing
section) are supplied with the unit.
To ensure their correct assignment to the individual components of the unit,
they are numbered accordingly.
The double frame capping section is screwed to the internal frame corners
after the assembly of the unit sections.
The plastic cover strip is glued to the unit cube frame before the unit cubes
are assembled. For this purpose, it has an adhesive strip on one side.
In the case of disassembled units, for which the frame capping cannot be
installed by the manufacturer and which at the same time use plastic internal
frame corners, these internal frame corners cannot be pre-installed in the cube.
In this case, the required number of plastic internal corners - labelled
accordingly- are supplied with the unit.
For assembly, the internal plastic corners are, after removal of the unit panels,
inserted into the corners of the unit frame and screwed to the frame with the
capping sections.
Gigant
9
Hide quick links:
Advertisement
