Lcd Display; Touch Panel - Janome 5300QDC Instruction Book

e r
w
q
y
u
i
q w
t y
e r t

LCD Display

NOTE:
Do not use the machine near appliances that generate
microwave ovens.
The LCD display shows following information when the
machine is turned on.
q
w
e
r
t
y

Touch Panel

q Mode key
When the power switch is turned on, the direct pattern
selection (mode 1) is set automatically.
Press the mode key to change the mode. Refer to
page 24.
w Clear key
Press the clear key to cancel the input and select the
Press the clear key to clear the registered stitch
pattern.
Press and hold the clear key until the buzzer beeps to
clear whole pattern combination. Refer to page 70.
e Mirror image key
pattern vertically. Refer to page 63.
r Memory key
Press the memory key to register the selected pattern.
Refer to page 61.
t Number keys (Refer to page 24)
You can select the stitch patterns from 01 to 10
directly in mode 1 (direct pattern selection mode).
Enter a 2-digit pattern number to select the desired
stitch pattern in modes 2 to 5.
y Stitch width adjusting key
Press "+" or "–" to change the stitch width or needle
drop position, depending on the selected stitch
pattern. Refer to pages 29, 32, 39 and 50.
u Stitch length adjusting key
Press "+" or "–" to change the stitch length of the
density, the evenness of darning, and the size of
eyelet with this key. Refer to pages 29, 32, 39, 44 and
46.
i Cursor key
Press " " or " " to move the cursor to check or edit
the pattern combination. Refer to pages 69 and 70.
11