FOREWORD RF Energy Exposure and Product Safety Guide for Portable Two-Way Radios ATTENTION! Before using this product, read the RF Energy Exposure and Product Safety Guide that ships with the radio which contains instructions for safe usage and RF energy awareness and control for compliance with applicable standards and regulation.
Page 4
DESCRIPTION The Tactical PTT/VOX Interface Module with Ear Microphone consists of two parts, the Push-To-Talk (PTT) / Voice Operated Transmission (VOX) Interface Module and the Bone Conduction Ear Microphone. The PTT / VOX Interface Module is equipped with high performance VOX interface and a large PTT button.
Page 5
Audio Accessory Jack PTT / VOX Change-Over Switch Removeable Button Cloth Clip Guard Ring External PTT Terminal Covered with Waterproof Waris Connector Figure 1. Overview of Interface Module...
Page 6
Eartip Isolator Receiver Bone conduction microphone Connector Figure 2. Overview of the Bone Conduction Ear Microphone...
OPERATION Attaching Bone Conduction Ear Micro- phone to Interface Module 1. Insert the Bone Conduction Ear Microphone’s connector into the accessory jack of interface module. 2. Securely tighten the waterproof ring. Note: Always ensure the waterproof ring is securely tighten at all times, if the ring is loose, waterproof function will be lost.
Page 8
IMPORTANT: When not in use, cover the external PTT terminal with waterproof cap to keep out dust and water. Attaching Interface Module Connector To The Radio 1. Turn the radio OFF. 2. Connect the Interface Module connector to the radio. 3.
VOX Mode PTT Mode Figure 4-B Figure 4-A Figure 4. PTT / VOX Change-Over Switch Transmitting By Using PTT Mode 1. Rotate the change-over switch to PTT mode as shown in Figure 4-A. 2. Press and hold down the Interface Module or Remote PTT button and begin speaking in order to transmit.
Page 10
Detaching Interface Module Connector From The Radio Turn the radio OFF before removing the Interface Module connector from the radio. Detaching Bone Conduction Ear Micro- phone from Interface Module 1. Loosen the waterproof ring. 2. Remove the Bone Conduction Ear Microphone’s connector from the accessory terminal of Interface Module.
Page 11
PMLN5511_ Small Eartip 0180305J72 Cloth Clip MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC and are used under license. All other trademarks are the property of their respective owners.