Woods BATWING BW15.50E Operator's Manual page 68

Tandem Axle Installation
1. Raise unit and support with jack stands per diagram
on page 16 to take pressure from tires.
2. Remove wheel assembly from right spring arm hub
assembly from centre frame.
3. Remove axle hub from right spring arm.
4. Install drive type grease fitting in four holes in spring
arm.
5. Install tandem arm 1045738 as shown.
6. Install tandem arm 1045739 as shown, sliding both
axles into receiving tubes. Fasten with screws 3489
and nuts 1045624 provided.
7. Install axle/hub 1017050 and secure with screw 3489
and nut 1045624,reused or purchased separately as
needed.
8. Install wheel assembly.
9. Repeat for left spring arm of centre frame, using
1045850 in place of 1045738, installed from the
centre.
10. Repeat for wings if purchased, noting orientation of
parts to locate wheels in the correct position. Outer
wheel should be forward of inner wheel on both wings.
68 Parts - All Models
TANDEM AXLE (OPTIONAL)
FOR .60 & .70 SERIES MODELS ONLY
REF PART QTY
1 3489 8 HHCS 1/2 NC X 3 GR5 ZP
2 1043432 8 Zerk, 1/4 drive type
3 1045624 8 Nut, HFN 1/2 NC, Dri-Loc patch
4 1045738RP 1 WA, tandem arm, RT
5 1045739RP 1 WA, tandem arm, LT
6 1045850RP 2 WA, tandem arm
TIRE & HUB
SEE PAGE 65
DESCRIPTION
MAN1246 (04/10/2018)