Printer 900 Installation Guide
Installing the Printer 900
CAUTION: Unplug the terminal's power pack before con-
necting the Printer 900 to the terminal.
Before installing the Printer 900, you must have the
correct printer interface cable. The Accessories Section,
located on the last page of this installation guide, lists the
interface cable part numbers for different VeriFone
terminals.
Power
1. Connect the 3-pin plug from the printer power supply to
Connection
2. Plug the Printer 900 power pack into an indoor,
Terminal
3. Making sure that the arrow on the printer interface ca-
Connection
4. Plug the other end of the cable into your terminal's
5. Plug in the terminal's power pack
6
the power connector on the right side of the Printer
900 rear panel.
grounded AC outlet. The printer will now be turned on
and will run through a power-up routine. Do not install
or operate the Printer 900 outdoors.
ble connector is up, carefully plug the 8-pin mini-DIN
connector into the communications port on the left
side of the Printer 900 rear panel.
RS-232 8-pin port.
(not shown).
Figure 4. Printer Connections