1. Manuals
  2. Brands
  3. VeriFone Manuals
  4. Printer
  5. Printer 900
  6. Installation manual

VeriFone Printer 900 Installation Manual

Verifone installation guide printer 900
Hide thumbs Also See for Printer 900:
Table of Contents

Advertisement

Quick Links

Download this manual
Printer 900
Installation Guide

Advertisement

Table of Contents
loading

Related Manuals for VeriFone Printer 900

Summary of Contents for VeriFone Printer 900

  • Page 1 Printer 900 Installation Guide...

  • Page 2: Table Of Contents

    No part of this publication may be copied, distributed, stored in a retrieval sys- tem, translated into any human or computer language, transmitted, in any form or by any means, without the prior written consent of VeriFone, Inc. VeriFone, ZON and TRANZ are registered trademarks of VeriFone, Inc.

  • Page 3: Introduction

    You should have the components shown in Figure 2 on the next page. Note: Save all packing material in case you ever have to ship the Printer 900 or move it to another location.
  • Page 4 Printer 900 Installation Guide Paper Roll Printer 900 Figure 1. Printer 900 Components 2. Place the printer on a solid desk or table top. When choosing a location for the printer, avoid areas with direct sunlight or objects that radiate heat...

  • Page 5: Setting The Internal Dip Switches

    Setting the Internal DIP Switches A set of four DIP switches is located under the paper holder on the bottom of your Printer 900. Make sure that these switches are set as indicated below before connecting and operating the printer. The printer will not operate properly if the switches are not set correctly.

  • Page 6: Installing The Printer 900

    Printer Connection 900 rear panel. 2. Plug the Printer 900 power pack into an indoor, grounded AC outlet. The printer will now be turned on and will run through a power-up routine. Do not install or operate the Printer 900 outdoors.
  • Page 7 Installing or 1. Remove the ribbon cover by pressing the front tab and lifting the cover up. Replacing the Ribbon 2. If you are replacing an old ribbon, pull up on the lift tab Cartridge on the right side of the cartridge (see Figure 6), remove the cartridge and discard it.
  • Page 8 Printer 900 Installation Guide Installing the The Printer 900 accepts paper that is 76mm wide. There are three different types of roll paper available from Paper Roll VeriFone. These are listed in the Accessories Section on page 11. Note: For best results, be sure the leading edge of the paper roll is cut cleanly rather than torn before feeding it into the printer.

  • Page 9: Installing The Paper Roll

    Paper Feed Path Paper Cavity Paper Roll Core Paper Support Arms Figure 8. Installing the Paper Roll (exploded view) To engage the auto feed mechanism, gently guide paper end into paper feed path. As soon as the sensor detects the Roll paper, the printer Cover...

  • Page 10: Running The Print Test

    Printer 900 Installation Guide Running the 1. Disconnect the power cord at the rear of the printer. Print Test 2. Hold down the paper feed button and plug the power cord back into the printer. Release the feed button when printing begins.

  • Page 11: Printer Specifications

    Printer Specifications Power Voltage: Requirements Power consumption: 45W max @ 100VAC input; 0.5 Amp (average) @ 120 VAC input Dimensions Height: and Weight Width: Depth: Shipping Weight: Footprint: 90 VAC–137 VAC, 47–60 Hz (low voltage version) 180 VAC–274 VAC, 47–60 Hz (high voltage version) 94.5 mm (3.72 in.) 156.0 mm (6.1 in.)

  • Page 12: Accessories

    The interface cables are listed here without length Cables: specification (-XX suffix). Normally, a -00 suffix denotes a 1 meter length. For other lengths, contact your VeriFone sales representative. For ZON Jr XL, XL300, TRANZ 3xx, OMNI 3xx, ZON II...

Table of Contents