Resetting The Recirculation Run Time - Rheem RTGH-RH11DV Use And Care Manual

f. Turn the dial . The start time on the screen will change in increments of thirty (30) minutes. When the desired start time appears on the
screen, press the button to select and store it. Next, turn the dial
button to select and store the end time. Repeat this step to set the start and end times for more days.
Figure 45 – Setting Start and End Recirculation Times
g. Press and hold the
h. If all settings are stored, press
▪3. Resetting the Recirculation Run Time
NOTE: This step is only necessary if the "Pro9" or "Auto" Recirculation Run Times need to be reset. If "Auto" was selected the water heater
will automatically program its recirculation operating patterns.
a. Enter the Recirculation Timer by pressing
b. Turn the dial until "cLr" flashes on the screen. Press the
See Figure 47.
c. Turn the dial to "Pro9" or "Auto". Press
button for two (2) seconds to store the time.
to return to Standby Mode.
Figure 46– Storing Recirculation Run Time
at Standby Mode while the water heater display is powered on.
Figure 47 – Resetting the Recirculation Run Time
at the Recirculation Timer Type you wish to reset. See Figure 48.
until the desired end time appears on the display. Press the
button at the "cLr" screen to reset the Recirculation Run Time.
66
AP18733 REV. 3.2.17