Table of Contents
Advertisement
Chapter 3 How to Use The Control Panel
f. Turn the dial
.The start time on the screen will change in increments of thirty (30) minutes. When the
desired start time appears on the screen, press the
until the desired end time appears on the display. Press the
Repeat this step to set the start and end times for more days.
Figure 45 – Setting Start and End Recirculation Times
g. Press and hold the
h. If all settings are stored, press
▪3. Resetting the Recirculation Run Time
NOTE: This step is only necessary if the "Pro9" or "Auto" Recirculation Run Times need to be reset. If
"Auto" was selected the water heater will automatically program its recirculation operating patterns.
a. Enter the Recirculation Timer by pressing
on.
b. Turn the dial
until "cLr" flashes on the screen. Press the
Recirculation Run Time. See Figure 47.
c. Turn the dial
to "Pro9" or "Auto". Press
Figure 48.
button for two (2) seconds to store the time.
to return to Standby Mode.
Figure 46– Storing Recirculation Run Time
at Standby Mode while the water heater display is powered
Figure 47 – Resetting the Recirculation Run Time
at the Recirculation Timer Type you wish to reset. See
button to select and store it. Next, turn the dial
button to select and store the end time.
button at the "cLr" screen to reset the
49
Hide quick links:
Advertisement
Table of Contents
