Plantronics CT10 User Manual page 8

CT10MultiLangInside.R1 7/3/00
IMPORTANT SAFETY INSTRUCTIONS
When using your telephone equipment, basic safety
precautions should always be followed to reduce the risk of
fire, electric shock, and injury to persons, including the
following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the
product. The symbol identifies and alerts the user to the presence of
important operating and service instructions.
3. Unplug this product from the wall outlet before cleaning.
Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for
cleaning.
4. Do not locate base unit near water, for example, near a
bathtub, wash bowl, kitchen sink, or laundry tub, in a
wet basement or near a swimming pool.
5. Do not place this product on an unstable cart, stand or
table. The product may fall, causing serious damage to the product.
6. This product should never be placed near or over a
radiator or heat register. This product should not be placed in a
built-in installation unless proper ventilation is provided.
7. This product should be used with the supplied Class 2
Direct Plug-In Power Unit rated 9 VDC 500 mA. Plantronics
Part No. 46924-01 has a rated input voltage of 120 VAC, 60 Hz and
an output voltage of 9 VDC at 500mA. Plantronics Part No. 46935-01
has a rated input voltage of 220 VAC - 240 VAC, 50 Hz and an output
voltage of 9 VDC at 500mA.
2:20 PM Page 2
2
IMPORTANT SAFETY INSTRUCTIONS
Do not allow anything to rest on the power cord. Do
8.
not locate this product where the cord will be abused by persons
walking on it.
9. Do not overload outlets and extension cords as this can
result in the risk of fire or electric shock.
10. Never push objects of any kind into this product
through base unit slots as they may touch dangerous voltage
points or short out parts that could result in a risk of fire or electric
shock. Never spill liquid of any kind on the product.
11. To reduce the risk of electric shock, do not disassem-
ble this product, but take it to qualified service personnel when
service or repair work is required. Opening or removing covers
may expose you to dangerous voltages or other risks. Incorrect re-
assembly can cause electric shock when the product is subsequent-
ly used.
12. Avoid using telephone equipment during an electrical
storm. The CT10 System has built-in surge protection circuits that
meet or exceed FCC requirements. However, an incident such as a
lightning strike at or near the telephone lines, could cause serious
damage. There may also be a remote risk of electric shock or dam-
age from lightning. If the CT10 System is installed in an area with
frequent and/or severe electrical storms, it is suggested that the
telephone be disconnected during these storms or that additional
surge suppression equipment be added to the installation.
13. Do not use the telephone equipment to report a gas
leak in the vicinity of the leak.
SAVE THESE INSTRUCTIONS
3