Starting, Operating, And Stopping The Machine - Husqvarna CT 36 Series Operator's Manual

Operation
4.12

Starting, Operating, and Stopping the Machine

Requirements ■ Fuel in fuel tank
■ Oil in the engine
Starting the Perform the procedure below to start the machine.
machine
1. Open the fuel valve by moving the lever to the right (k1).
► If the engine is cold, move the choke to the closed position (n1).
► If the engine is warm, move the choke to the open position (n2).
2. Turn the ON/OFF switch to the ON position (c1).
3. Move the throttle to the idle position (a1).
Note: The engine does not start unless the throttle is in idle position.
WARNING
Personal injury hazard. Placing foot on the ring guard when starting the engine may
cause severe injury if the foot slips through the ring guard.
► Do not place foot on the ring guard when starting the engine.
4. Pull the starter rope (d) until the engine starts.
This procedure continues on the next page.
a
a
1
b
a
2
k
k
k
k
2
2
c
2
c
1
38
Walk-Behind Trowels
1
1
n
m
1
1
d
wc_tx004127gb_FM10.fm
n
m
2
2
wc_gr001098
wc_gr013022