Installing Logs - Vanguard Gas Log Heater Owner's Operation Manual

INSTALLING
Continued
20

INSTALLING LOGS

Failure to position the parts in accordance with these diagrams or failure
to use only parts specifically approved with this heater may result in
property damage or personal injury.
For Vintage Oak Log Model
Each log is marked with a number. These numbers will help you identify the log
when installing. It is very important to install these logs exactly as instructed. Do
not modify logs. Only use logs supplied with heater.
1. Locate pegs on the bottom of back log (#1). Slide these pegs into the holes in
the grate base behind the burner (see Figure 16).
2. Locate the notches on the back of the front log (#2). Slide these notches over
the tabs of the grate base (see Figure 17).
3. Locate the notches in the bottom of the crossover log (#3). Place the crossover log
on top of the back log and front log. Make sure the notches of the crossover log line
up with rectangular knobs on top of the back and front logs (see Figure 18).
4. Add lava rock around base of heater.
Peg
Hole
Figure 16 - Installing Back Log
Crossover
Log (#3)
Notch
Rectangular Knob
Figure 18 - Installing Crossover Log
WARNING
WARNING ICON G 001
Back Log
(#1)
Notch
Peg
Tabs of
Grate Base
Figure 17 - Installing Front Log
Notch
Rectangular Knob
Front Log
(#2)
103515