Table of Contents
Advertisement
INSTALLATION
Continued
Figure 11 - Removing Shipping Brace
LAMPS AND LAvA ROCk
Before operating fireplace, lamp bulbs must
be inspected and lava rock may be added if
desired.
1. Lift log bed off hearth base to gain access
to lamp fixtures (log bed is attached with
contact magnets).
2. Turn on power to light circuit and check
that all bulbs are operating. Bulb place-
ment front left to right are red, yellow and
orange (see Figure 12).
Note: If bulbs need replacing, see Replac-
ing Light Bulbs, page 15. Be careful not to
tear or damage reflective strips. If they have
come loose, ends can be easily reattached or
replaced at support brackets. See Replacing
Reflective Ribbons, page 19.
3. Center log bed over opening between
viewing panel screen and grate.
4. Cover remaining hearth area with 1/4" of
lava rock (provided), if desired.
Viewing Panel
Screen
Red
Yellow
Orange
Grate
Log Bed
Figure 12 - Bulb Placement
115121-01B
This electronic fireplace series features a
random flame effect, and a realistic log bed
with glistening embers that can be adjusted
for flame speed and light intensity. VE36/32LH
models have a circulating heater, rated at
Motor
1100 Watts. Models VE36/32LB and VE36/
Mount
32LBH include a hand detailed, textured,
red-brick lining.
Foam
Access controls by pulling two handle tabs
Shipping
of upper louver until panel releases from
Brace
magnetic catches and swings down to open
position (see Figure 13).
Figure 14, page 8, shows control layout for
heater equipped models with main power
switch to flame controls and heater power
switch (when equipped) to heating unit. This
allows independent and efficient operation of
both features.
Once main power is turned on, flame speed
and brightness may be turned on and adjusted
independently.
www.desatech.com
FEATURES AND
OPERATION
Figure 13 - Accessing Controls
7
Advertisement
Table of Contents
