Table of Contents
Advertisement
ON/OFF
Flame Speed
Switch
MAIN
HI- OFF
LOW
POWER
FLAME SPEED
Flame Brightness
ACCESSORy
INSTALLATION
OPTIONAL GLASS DOORS
Models VE36L and VE32L will accept bifold
glass doors that are fully operable or a fixed
panel door that limits access to fireplace, (see
Accessories, page 23).
Installing Bifold Glass Doors
Follow these steps to install left and right
operable panels:
1. With handle down, completely fold panel
on its hinges.
2. With handle facing center of firebox open-
ing insert lower pivot pin on door panel
into hole in bottom outer edge of firebox
opening (see Figure 15).
3. Keep folded door tilted and slide upper two
pins into guide track below upper facial
edge of firebox opening.
4. Tilt glass assembly fully vertical until outer
pivot pin snaps into mounting hole in up-
per spring clip.
5. Once top and bottom pins are secured,
unfold door into closed position.
6. Repeat steps 1 through 5 for opposite
door assembly.
7. To adjust doors, slide partially open.
Using a Phillips screwdriver, loosen hold-
down screws on spring clips (see Figure
16).
8. Close both doors until evenly joined at
middle and note gap as measured to outer
edges of front face.
9. Reopen each door one at a time and
retighten the hold-down screw while pre-
serving noted gap at each edge.
10. Repeat process until both doors are even-
ly joined, spaced and working freely.
8
FEATURES AND OPERATION
HI- OFF
LOW
FLAME BRIGHTNESS
Figure 14 - Control Panel
www.desatech.com
Continued
Figure 15 - Installing/Removing Glass
Side Front
Face
Partially
Opened
Door
Figure 16 - Adjust Glass Door
Heater Switch
HEATER
Spring Clip
Depress Spring
Clip to Release
Pivot Pin
Fold Bifold Door
After Releasing
Spring Clip to
Slide Door Out of
Upper Track
Remove Pivot Pin
From Bottom Face
While Sliding Door
Out of Upper Track
Pivot Pin
Doors
Spring Clip
115121-01B
Advertisement
Table of Contents
