Product Identification; Product Features; Air For Combustion And Ventilation - Vanguard VSGF28NTD Installation Manuals

PRODUCT IDENTIFICATION

4

PRODUCT FEATURES

AIR FOR COMBUSTION AND VENTILATION

PRODUCT IDENTIFICATION
Middle Log
Front Log
Front Burner
Figure 1 - Log Base Assembly, Split Oak Set
Top Louver
f i r e - p a r t s . c o m
Assembly
Fireplace
Hood
Firebox
Support
Screen
Assembly
Figure 2 - Fireplace
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Rear Burner
Rear Log
Top Outer
Casing
Blower
Assembly
Bottom Louver
Assembly
PRODUCT FEATURES
OPERATION
This vent-free fireplace is clean burning. It requires no outside
venting. There is no heat loss out a vent or up a chimney. Heat is
generated by both realistic flames and glowing embers. When used
without the blower, the fireplace requires no electricity making it
ideal for emergency backup heat.
SAFETY DEVICE
This fireplace has a pilot with an Oxygen Depletion Sensing (ODS)
safety shutoff system. The ODS/pilot is a required feature for vent-
free room heaters. The ODS/pilot system shuts off the fireplace if
there is not enough fresh air.
PIEZO IGNITION SYSTEM
This fireplace has a piezo ignitor. This system requires no matches,
batteries, or other sources to light fireplace.
BLOWER ASSEMBLY
This fireplace has a blower assembly. The blower operates
thermostatically and has a variable speed control. The blower circulates
heated air from the fireplace into the room. Use of blower is optional.
THERMOSTAT CONTROL
This fireplace has a thermostat sensing bulb and a control valve. The
thermostat controls the heat output and flame height. This maintains a
consistent room temperature. Even the lowest setting provides realistic
flames and glowing embers from two burners. Selecting higher comfort
settings allows fireplace to run longer, producing greater heat output. At
lower comfort settings, the fireplace will run less. This results in
increased heating comfort. This can also result in lower gas bills.
AIR FOR COMBUSTION AND
VENTILATION
WARNING: This heater shall not be installed in a
confined space or unusually tight construction un-
less provisions are provided for adequate combus-
tion and ventilation air. Read the following instruc-
tions to insure proper fresh air for this and other fuel-
burning appliances in your home.
Today's homes are built more energy efficient than ever. New mate-
rials, increased insulation, and new construction methods help reduce
heat loss in homes. Home owners weather strip and caulk around
windows and doors to keep the cold air out and the warm air in. During
heating months, home owners want their homes as airtight as possible.
111149-01B