St743A/St744A/St748A - Mitsubishi Electric MR-J5 User Manual

ST743A/ST744A/ST748A

Cable structure
Prepare a cable based on the following configuration diagram.
■For linear servo motors
• MR-J5-_/MR-J5W_-_G_
MR-J5-_
CN2
or
MR-J5W_-_G_
CN2A
CN2
CN2B
*1
CN2C
Equipment required to adjust and check signals
Software for
signal adjustment
Conditions
When using an optional
encoder cable
When fabricating the
encoder cable
When not using a branch
cable
*1 The connection to CN2C is for the MR-J5W3-_G_. The MR-J5W2-_G_ does not have CN2C.
*2 Supplied by customer
*3 In order to adjust and check signals when installing the ST743A, ST744A, or ST748A, a personal computer, signal adjustment software,
and a converter unit are required. For further details contact Mitutoyo Corp.
*4 For thermistor signal connectors, change the connection method depending on the system being used.
1 LINEAR ENCODER
16
1.3 Linear encoder manufactured by Mitutoyo (absolute type)
Encoder cable 2
(5)
Branch cable
(4) SCALE
*4
THM
*3
Personal
computer
Conversion unit
Branch cable Encoder cable
(4) MR-J4THCBL03M (1) Options manufactured by Mitutoyo
Page 74 MR-
Part No.06ACF117A: 5 m
J4THCBL03M branch cable Part No.06ACF117B: 10 m
(2) MR-J3CN2 connector set
Page 20 Encoder cable 1
 (5) MR-J3CN2 connector set
Page 21 Encoder cable 2
Encoder cable 1
(1)
(2)
Linear servo motor thermistor
(3) Junction connector
15-pin D-SUB (female)
Shell: HDAB-15S
Plug case: HDA-CTH (Hirose
Electric)
(3)
Linear servo motor thermistor
Linear encoder
ST743A/ST744A/ST748A
Head cable
(3)
Head cable
*2
Linear encoder accessory
Cable length: 1 m
*2