Table of Contents
Advertisement
MOUNT ADAPTER MEASUREMENT
With vehicle on level ground, measure from ground to
center of the hole on U-bracket sideplate on mount.
The recommended height of the mount should be
14-1/4" or less from the center of the U-bracket hole
to level ground. If the mount is higher than 14-1/4",
the enclosed adapter plates need to be attached to
the Mount Adapter. (The Mount Adapter comes
packaged with the Blade Crate Assembly.)
If measured height is 14-1/4" or less, no height
adjustment is needed.
Center
of Hole
Mount
Adapter
14-1/4"or less
If measured height is 14-1/4" – 15-3/4", install the
short height adjustment adapter plates as described.
Center
of Hole
Mount
Adapter
14-1/4" – 15-3/4"
Lit. No. 40388, Rev. 00
MOUNT ADAPTER INSTALLATION
Mount
Mount
Adapter
Plate
MOUNT ADAPTER INSTALLATION
If adapter plates are required, install as follows:
1. Position the adapter plate against the driver's
side portion of the mount adapter as shown. Insert
a 3/4" x 2-3/4" cap screw through the lower front
adapter plate hole and through the appropriate
hole on the mount adapter. Secure with a locknut.
2. Insert a cap screw through the rear adapter plate
hole, through the slot on the mount adapter and
through a washer. Secure with a locknut.
Mount Adapter
3. Repeat for the passenger's side. Torque all four
fasteners according to torque chart on page 4.
NOTE: After five to ten hours of snowplow usage,
retorque all mount assembly fasteners.
8
Adapter
Plate
May 15, 2008
Advertisement
Table of Contents
