Table of Contents
Advertisement
5. Install a 7/16" x 1-1/4" cap screw with flat washer
through slot in mount and frame cross member.
Place a 7/16" washer between the mount and
cross member. Loosely fasten 7/16" flat washer
and locknut. Do not tighten any fasteners until
instructed to do so.
Washer
7/16" x 1-1/4" Cap Screw,
Washer and Locknut
Lit. No. 40388, Rev. 00
UNDERCARRIAGE INSTALLATION
6. Repeat steps 2, 3, 4 and 5 for the passenger-side
mount. Insert a 1/2" x 1-1/4" cap screw with
handle in through the square hole with the bumper
brace attached and out through frame and top
hole on mount. Fasten with 1/2" locknut.
7. Reattach the sway bar brackets to the mounts and
frame with four M10 x 1.5 x 40 cap screws, flat
washers and lock washers.
M10 x 1.5 x 40
Cap Screw
and Washers
(Viewed from the back)
8. Tighten the sway bar bolts first and then all
remaining fasteners. Tighten all fasteners per
torque chart. Bend or trim the handles on all cap
screws with handles to prevent contact with any
vehicle components.
7
U-Bracket
Driver-Side
Receiver
May 15, 2008
Advertisement
Table of Contents
