Fingerprint Sensor Assembly - HP mt22 Maintenance And Service Manual

Fingerprint sensor assembly

Table 5-11 Fingerprint sensor assembly descriptions and part numbers
Description
Fingerprint sensor assembly
Fingerprint sensor bracket (included in Bracket Kit)
Fingerprint sensor cable (included in the Cable Kit)
Fingerprint sensor insert (included in Plastics Kit; for use in models without a fingerprint sensor)
Before removing the fingerprint sensor assembly, follow these steps:
1. Prepare the computer for disassembly
2. Place the computer in Battery Safe mode
3. Remove the following components:
a. Bottom cover
b. Battery
Remove the fingerprint sensor assembly:
1. Disconnect the cable from the ZIF connector on the fingerprint sensor (1).
2. Lift the two plastic tabs that hold the bracket in place (2).
3. Slide the bracket toward the inside of the computer, and then lift it off the fingerprint sensor board (3).
TIP:
4. Remove the fingerprint sensor from the computer (4).
Reverse this procedure to install the fingerprint sensor assembly.
42 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Bottom cover on page
(Battery on page 31).
You might need a tool to release the bracket.
(Preparation for disassembly on page
(Battery Safe mode on page
30).
Spare part number
L77229-001
L77264-001
L77263-001
L77265-001
29).
29).