Ax-600De/3200De - US Amps AX Installation Manual

1
INPUT
(Shown here is AX-600DE, but the diagram is also applicable to AX-3200DE.)
Amplifier Input
1
operation.
Input Gain
2
is variable from 150 mV to 3 volts for full output. Best results are achieved
by adjusting the control to the lowest setting in relation to the output of the source unit.
Low-pass Crossover Control
3
For the internal amplifier, adjustable from 50 Hz to 500 Hz @ 24dB.
4 Remote Bass Gain
control harness to allow the amplifier volume to be controlled from the passenger
compartment.
5
The Magic Switch
power by discarding frequencies below 36Hz.
The center "XOver" defeats the Subsonic Filter tor amplifier operation down to 5 Hz.
The far right "Slave" position defeats all amplifier controls to receive information through the Remote
Bass Gain wires from another "master" amplifier.
This can be repeated as often as necessary with all slave units receiving Identical gain, frequency, and
subsonic functions from the master amplifier.
A single Remote Bass Gain can be connected at any point to universally control the volume of the
entire amplifier bank.
WARNING:
DO NOT use ground-loop isolation devices or high/low conversion devices
on the input of your U.S.Amp!
2 3 4
L
Min 50 500
INPUT SUB
Gain Freq
RBG
R AX-600DE
One Ohm Stable Design
The amplifier MUST receive input on BOTH RCA jacks for proper
A two-position removable plug that accepts the included RBG
The far left "Subsonic Filter" position makes more efficient use of amplifier
All U.S.Amps require a grounded input connection.

AX-600DE/3200DE

Class "DE" Amplifiers
Controls and Features
5
Subsonic
Slave
PWR Prot
Class DE Digital Amplifier
XOver
U.S.A.
1200 Watts Dynamic Power
600 Watts RMS Power
8