Wired Remote Controller Installation - LG ATNH12GPLE1 Installation Manual

Wired remote controller installation

- Since the room temperature sensor is in the remote controller, the remote controller box should
be installed in a place away from direct sunlight, high humidity and direct supply of cold air to
maintain proper space temperature. Install the remote controller about 5ft(1.5m) above the floor
in an area with good air circulation at an average temperature.
Do not install the remote controller where it can be affected by:
- Drafts, or dead spots behind doors and in corners.
- Hot or cold air from ducts.
- Radiant heat from sun or appliances.
- Concealed pipes and chimneys.
- Uncontrolled areas such as an outside wall behind the remote controller.
- This remote controller is equipped with a seven segment LED. display. For proper display of the
remote controller LED's, the remote controller should be installed properly as shown in Fig.1.
(The standard height is 1.2~1.5 m from floor level.)
N
TIO
NC
B FU he at
SU Pre mi dif y
D ate r Hu or
EE He st t do
N SP AU TO De fro Ou
FA JE T Fil ter 4
M P HI 2 3
ME D 1
T TE p
SE Tem LO
Ro om NE 23
IO N ZO 21
AT
ER 19
OP e 17
IN G Ti m 15
SW set
TO gra m 13
AU Pro 11
09
it
n un 07
era tio 05
Op 03
er
m f 01
Ti Of Tim e
On t no.
Se
no
REMOTE CONTROLLER INSTALLATION
Direct
Sun ray contact area
yes
no
5feet
(1.5meters)
N
NC TIO
B FU he at
SU Pre y
D r mi dif
EE He ate Hu t do or
SP AU TO fro Ou st
FA N De 4
JE T Fil ter 3
M P HI 2
T TE p ME D 1
Tem
SE om LO 23
N Ro ZO NE 21
IO AT
ER 19
OP e 17
IN G m
Ti set 15
SW m 13
AU TO Pro gra
11
09
it
n un 07
tio 05
Op era
03
m er f 01
Ti Of e
On Tim
Se t no.
no
21