Installation Of Wireless Remote Controller; Installation Of Wired Remote Controller - LG Multi V 2 Series Installation Manual

Installation of Wireless Remote Controller

How to mount onto a wall
How to insert the batteries
1. Remove the battery cover by pulling it according to the arrow direction.
2. Insert new batteries making sure that the (+) and (-) of battery are
installed correctly.
3. Reattach the cover by sliding it back into position.
NOTICE
1. Always use/replace both batteries of same type.
2. If the system is not to be used for a long time, remove the batteries to
save their working life.
3. If the display screen of remote controller starts, fading replace both of
the batteries.

Installation of Wired Remote Controller

1. Connect the wired remote controller cable
to the wired remote controller installation
board as shown in the right picture.
12V Red wire
SIG Yellow wire
GND Black wire
❊ The wired remote controller cable is connected as factory default.
2. After fixing the cable to the guide slot,
attach the wired remote controller installa-
tion board at the desired location.
• Before fixing the wired remote controller cable
to the guide slot, remove any clogged part of
the case in the direction to install before the
installation.
12V SIG GND
Red
Yellow
Black
<Front side of
installation board> installation board>
Installation Manual 15
Installation
Remote Controller
Cable
Guide slot
<Rear side of