Table of Contents
Advertisement
NOTE:
This section applies ONLY if you already have Dell Networking OS 9.x
installed on your system from the factory. If you are installing a third-party OS, see
your third-party OS documentation.
NOTE:
For further information on the S4048T-ON system, see the documents listed
in
About this
guide.
Topics:
•
Initial configuration information
•
Navigating CLI modes
•
Console access
•
RJ-45 console port access
•
Default configuration
•
Layer 2 data link configuration
•
Host name configuration
•
Remote access
•
Enable password configuration
•
Port-based VLAN creation
•
System connection
Initial configuration information
To set up the switch, assign an IP address and other configuration information necessary for
the switch to communicate with the local routers and the Internet. The minimal configuration
provided here does not cover most of the features. This information simply allows you to
perform other configuration tasks using a Telnet connection from your management
network.
Software configuration
Software configuration
4
25
Advertisement
Table of Contents
