IRiver Kyobo sam User Manual page 31

Insert/remove the SD Card
1. Gently insert and push the Micro SD card in the card slot as
shown in the figure below while the product is powered off.
2. Gently press the SD card again to remove it.
Recommended SD Cards
Brand: SanDisk, Transcend
Insert/remove the SD card when the product is powered off. To
avoid damage, do not apply excessive force when inserting the
SD card. Do not repeatedly insert/remove the SD card.
Doing so may delete data, damage the EB12 or cause damage to
the SD card.
Improper handling of the SD card may cause damage to the EB12
or to the SD card.
If an SD card is not installed properly, a display error may result
and the SD card may not be separated smoothly. Use of an
unauthorized SD card may result in a malfunction of the EB12.
Transfer speed of the SD card may vary depending on the PC status.
An SD card cannot be formatted from the device. To format,
connect the device to a card reader or computer with UMS.
Formatting the SD card deletes all data. Please back up the card
before formatting it.
Please format the SD card as FAT 32 system and format any SD
card that is not recognized or may cause damage to the EB12 or
to the SD card. An SD card is sold separately.
SD cards up to 32 GB are supported by the EB12.
0 9
Getting Started