Maritime Radio Services Operation - Uniden UM-525 Owner's Manual

Maritime Radio Services Operation

Maritime Radio Services Operation
Warning! This transmitter will operate on channels/frequencies that have restricted use in
the United States. The channel assignments include frequencies assigned for exclusive use
of the U.S. Coast Guard, use in Canada, and use in international waters. Operation on
these frequencies without proper authorization is strictly forbidden. For frequencies/
channels that are currently for use in the U.S. without an individual license, please contact
the FCC Call Center at 1-888-CALL-FCC.
For individuals requiring a license, such as commercial users, you should obtain a license
application from your nearest FCC field office (for US users) or Industry Canada (for Canadian
users).
FCC / Industry Canada Information
Certification FCC Part 80 or RSS-182/188
Output Power 1 Watt (low) and 25 Watts (high)
Emission 16K0F3E, 16K0F2D
Transmitter Frequency Range 156.025 to 157.425 MHz
FCC Identifier AMWUT601
IC Certification Number 513C-UT601D
This device complies with the GMDSS provisions with Part 80 of the FCC Rules, as well as
Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause
harmful interference.
Unauthorized changes or modifications to this equipment may void compliance with the FCC
Rules. Any change or modification must be approved in writing by Uniden Corporation.
Changes or modifications not approved by Uniden could void the user's authority to operate
the equipment.
The cords on this product and/or accessories contain lead, a chemical known to the State of
California to cause birth defects or other reproductive harm. Wash hands after handling.
Uniden works to reduce lead content in our PVC coated cords in our products and accessories.
Installer Instructions
To connect an optional external antenna to the radio for your WHAM x 4, you will need a
2.4GHz antenna with mounting bracket and a cable with N-type connectors. Keep the
antenna lead-in wire as short as possible.
Follow these steps to connect an optional external antenna to the radio.
1. Use a mounting bracket to mount the antenna on a vertical mast or pole.
2. Run the cable from the antenna to the radio.
3. Attach one end of the cable to the connection lug on the antenna, then connect the other
end to the External Antenna Connector jack on the back of the radio.
2
Maritime Radio Services Operation