Table of Contents
Advertisement
Care and Maintenance
General Use
• Turn the scanner off before disconnecting the power.
• Always write down the programmed frequencies in the event of memory loss.
• If memory is lost, simply reprogram each channel. The display shows 000.0000 in all
channels when there has been a memory loss.
• Always press each button firmly until you hear the entry tone for that key entry.
Location
• Do not use the scanner in high-moisture environments such as the kitchen or bath-
room.
• Avoid placing the unit in direct sunlight or near heating elements or vents.
• If the scanner receives strong interference or electrical noise, move it or its antenna
away from the source of the noise. If possible, a higher elevation might provide better
reception.
• Also try changing the height or angle of the antenna.
Cleaning
• Disconnect the power to the unit before cleaning.
• Clean the outside of the scanner with a mild detergent.
• To prevent scratches, do not use abrasive cleaners or solvents. Be careful not to rub
the LCD window.
• Do not use excessive amounts of water.
Repairs
Do not attempt any repair. The scanner contains no user serviceable parts. Contact the
Uniden Customer Service Center or take it to a qualified repair technician.
Birdies
All radios can receive "birdies" (undesired signals). If your scanner stops during Scan
mode and no sound is heard, it might be receiving a birdie. Birdies are internally generated
signals inherent in the electronics of the receiver.
Press L/O to lock out the channel, then press SCAN to resume scanning.
Care and Maintenance
46
Advertisement
Table of Contents
