Installing Your Scanner; For Home Use (Desktop Installation) - Uniden BC 898T Owner's Manual

These guidelines will help you install and use your new scanner:
• If your scanner receives interference or electrical noise, move the scanner or its
antenna away from the source. You might also try changing the height or angle of the
telescoping antenna.
• To improve the scanner's reception, use an optional external antenna designed for
multi-band coverage. (You can purchase this type of antenna at a local electronics
store). If the optional antenna has no cable, use 50-70 ohm coaxial cable for lead-in.
A mating plug might be necessary for the optional antennas.
• Use an optional earphone or stereo headset with proper impedance for private
listening. Read the precautions on the inside front cover of this Owners Manual.
• Do not use the scanner in high-moisture environments such as the kitchen or
bathroom.
• Avoid placing the scanner in direct sunlight or near heating elements or vents.

For Home Use (Desktop Installation)

1. Insert the DC plug end of the included AC adapter into the DC 12V jack on the back of
the scanner.
2. Plug the other end of the AC adapter into a standard 120V AC wall outlet.
3. Plug the included telescoping antenna into the ANT connector on the back of the
scanner. Then extend the antenna to its full height.
Note: For frequencies higher than 406 MHz, shortening the antenna might improve the
reception.
4. Use the scanner's desktop stand for a better viewing and operating angle.

Installing Your Scanner

Remote Jack
DC 12V
Power Jack
Antenna Jack
Plug
15
Telescoping
Antenna