All manuals and user guides at all-guides.com
UBC61 scanner Qk
3/12/02 11:22 AM Page 4
SETUP
Installing the Batteries
1.Open the cover
Lift
Press in
2.Insert Batteries
Ni.-Cd.
REG.
BATT.
ALK.
BATT.
Inside
of top
cover
Note: If you are installing alkaline batteries, set the
switch to REG. ALK.BATT. If installing nickel-
cadmium batteries, set the switch to Ni-Cd
BATT.
3.Replace cover and press down
until it clicks into place.
Do not mix alkaline
batteries with Ni-Cd
batteries. Be sure to
WARNING
install four batteries
of the same type.
AC Adapter/Charger
Use the optional AC adapter/charger to power the
UBC61XLT from an AC outlet.
Use only the optional AC adapter.
Charging Warning
Do not charge alkaline batteries in this scanner.
Doing so may cause serious damage to the prod-
uct and void the warranty. Before attempting to
recharge batteries, make sure you have installed
four rechargeable nickel-cadmium batteries and the
selector switch is set to Ni-Cd BATT.
Flexible Antenna
Attach the flexible
antenna to the BNC
connector.
Belt Clip
Do not tighten the
screws too tight. You
can damage the case
or clip.
Optional Accessories
AC Adapter / Charger
Cigarette Lighter Lead
4