Searching For And Temporarily Storing Active Frequencies - Uniden UBC93XLT Owner's Manual

2 seconds after the end of a transmission before
scanning proceeds to the next channel. To turn
the function off or on, press Func + Dly.
• If you enter a frequency that has already been
entered elsewhere, the scanner sounds an error
tone and displays the channel that was
duplicated. If you entered the frequency by mis-
take, press
To enter the frequency anyway, press E to
accept.
4. To program the next channel in sequence, press
E/Pgm then repeat Steps 2 and 3.
Searching For and Temporarily
Storing Active Frequencies
If you do not have a reference to frequencies in your
area, use a search to find a transmission.
There are two search features available. Service
Search (see below) and Chain Search on page 38.
Note: When the scanner starts searching, it auto-
matically turns on the delay function. To turn delay
on or off, press Func + Dly.
Service Search
You can search for police, railroad, marine, aircraft,
UHF CB, and AM CB transmissions without knowing
the specific frequencies used in your area. The
scanner is preprogrammed with all the frequencies
allocated to these services. To use this feature,
press Func + Svc. SRCH appears and the scanner
searches starting with the police service bank. To
select a different service bank, repeatedly press
Func + Svc. Service mode appears on the display.
When the scanner stops on a transmission, press
Hold to stop searching and listen to the
transmission. Hold appears. In this mode, you can
then enter the correct frequency.
31
Operation