Programming Ltr Systems - Uniden BC296D Owner's Manual

Programming LTR
Follow the instructions in this section to program information
for LTR trunking systems. For more information about LTR
systems, refer to "Understanding Scanning."
2:SCAN OPTION → 2:TRUNK → Enter the bank
→ 1:TRUNK TYPE → 1:ON → 9:LT →
2:TRUNK CHANNEL
1. Enter the channel number.
1:FREQUENCY
2. Enter the frequency and alpha tag for the channel.
Repeat these steps for all channels in the system. Then,
refer to "Programming Talkgroups."
Note: LTR systems must be programmed in channel order,
skipping unused channels. For example, if the LTR
system you are programming uses only Channels 1, 3,
5, and 7, program frequencies in the first, third, fifth,
and seventh channels in the bank.
Systems
58