Table of Contents
Advertisement
3:SYSTEM OPTION → 6:CLONE
on both scanners. Then, on the scanner that has the data you
want to transfer, select MASTER and press E. On the scanner
that you want to transfer the data into, select SLAVE and
press E. Then, press SCAN on both scanner to start the
transfer.
Caution: This deletes all data from the unit you select as
SLAVE. Make certain that you pick the correct set-
tings for each scanner to prevent data loss.
During transfer both scanners display the following.
When transfer is complete, the scanners display COMPLETE.
Turn both scanners off and then back on to initialize them.
If data transfer is not successful, the following message
appears.
To clear the error, press
repeatedly press MENU/BACK.
CLONE
== >
MASTER UNIT
. To exit the clone mode,
.
CLONE
== <
SLAVE UNIT
CLONE
ERROR
MASTER UNIT
62
Advertisement
Table of Contents
