Selecting A Memory - Uniden BC370CRS Owner's Manual

Bank 26
251 261
252 262
253 263
254 264
255 265
256 266
257 267
258 268
259 269
260 270
Once you fill out the above chart, follow these steps to enter or change a
frequency in a memory:
1. Press E/PGM to enter the program mode (the scanner turns on the
icon).
PGM
2. If the current channel is not the one you want to program, enter the
memory number then press HOLD.
3. Enter the frequency including the decimal point, then press E/PGM.
4. To program the next memory, press L or M and repeat step 3.
To program a different memory, repeat from step 2.
5. To exit program mode, press HOLD or SCAN or change the scanner's
mode.
Notes:
• Any frequency you program replaces the previous memory contents.
• If you enter a frequency you have already stored in a different
memory in Step 3, the scanner beeps and displays the channel
where you have previously stored the frequency. If you want to store
the frequency anyway, press E/PGM a second time in Step 3.
• To clear the contents of a memory, enter "0" in Step 3.
• Channels you program are automatically unlocked (see "Locking/
Unlocking Memories) and have Delay turned on (See "Setting
Channel Delay").

Selecting a Memory

To select a single memory to monitor, press HOLD. The scanner turns on
icon. Then, select a memory by pressing L or M to go to the
the
HOLD
memory or input the memory number then press HOLD.
30
Bank 27
271
272
273
274
275
276
277
278
279
280
Bank 28
281
282
283
284
285
286
287
288
289
290
Using the Scanner Memories
Bank 29 Bank 30
291
292
293
294
295
296
297
298
299
300