Led Signal Strength Meter In City Mode; Safety Warning System Operation - Uniden LRD 737 Operating Manual

Uniden radar detector operating guide lrd 737

Table of Contents

LED Signal Strength Meter in City Mode

The LED signal strength meter gives you instant information about the

strength of the signal being detected. A weak signal causes the first LED

to light, but as signal strength increases, more LEDs light. All three LEDs

light when full signal strength is received. Use this meter to judge the

distance from the signal source.

Signal Strength

The Safety Warning System (SWS™) is a new communication system

that will provide an early warning when a road hazard exists. The

LRD 737 is capable of detecting the SWS signal broadcast on the K-band

by either law enforcement or local departments of transportation. The

yellow SWS LED lights, while an audible alert sounds. When this alert

sounds, you should tune to local radio traffic reports or prepare to slow

down or stop your vehicle because you could be approaching an accident,

bad road conditions caused by weather, or road crews or construction.

Visual

Visual/Audio

Ka-SuperWideB

and and SWS

Visual/Audio

Laser (Red) and

Laser2 (Amber)

Visual/Audio

Table of Contents