Open Scan Mode - Uniden uh065sx Owner's Manual

UNIDEN Model uh065sx UHF CB Radio
OPERATION
OPEN SCAN (OS) Mode
on OS mode)
Allows continuous scanning of channels stored in the Open Scan (OS) memory.
If an active channel is found, scanning will stop on that channel.
Example. CH40 becomes active
If the received signal cease, the unit will wait
for at least 3 seconds for the signal to return,
otherwise scanning resumes.
To skip the active channel, press
To deactivate SCAN, press the
uh065sx OM.indd Sec1:15 uh065sx OM.indd Sec1:15
(the absence of GS icon indicates that the unit is
The factory has preprogrammed all the 40 UHF channels into
the Open Scan channel memory. However, you can change or
customise the channels by following the steps on programming
Scan Channels on page 17.
or
,
DUAL
1. If SCAN is deactivated while in an active channel,
the uh065sx will stay on that active channel. If no
other channels are active, the uh065sx will reinstate
the starting channel.
2. If OS Scanning is initiated when there are no
channels programmed in OS memory, an error tone
will be heard and scanning will not start.
. Scanning resumes.
or .
15
17/8/07 3:00:31 PM 17/8/07 3:00:31 PM