Roland REAC R-1000 Reference page 3

Connection with the control computer
1.
Power off the R-1000 and the computer.
2.
Use an RS-232C cable to connect the RS-232C connector of your computer to the RS-232C connector located on the back of
the R-1000.
For details on the cable to use, refer to "Connector and cable" (p. 2).
Settings on the control computer
Communication settings on the computer
• Communication method
• Communication speed
• Parity
• Data length
• Stop bit
• Code set
• Flow Control
* For details on how to set the communication settings, refer to the owner's manual of the computer you're using.
Settings on the R-1000
When you power up the R-1000, the communication speed will be set to 115200 bps by default. If you're using the R-1000 via RS-
232C, you'll need to set its communication speed to match the setting of the computer.
For details on how to set this, download "R-1000 Application Guide" from the Roland website below and refer to it.
http://www.rolandsystemsgroup.net/
Synchronous (asynchronous), full-duplex
4800 / 9600 / 14400 / 31250 / 38400 / 57600 / 115200 bps
(You can select this as desired, but it must be the same as the setting on the R-1000.)
none
8 bit
1 bit
ASCII
none
Setup
3