Roland Edirol R-09HR Quick Manual

®
e
Welcome
Congratulations on your purchase of the EDIROL R-09HR WAV/MP3 Recorder. This
TurboStart contains step-by-step instructions that will quickly introduce you to the
R-09HR's major features.
Recording
The R-09HR offers high-quality recording capabilities in a compact package. Here's how
to record in the R-09HR using its built-in microphone:
1 Turn on the power by holding down the R-09H's right-side-panel POWER button
for a few seconds..
2 Press the button—its light flashes to indicate you're in Record-Standby mode.
n
3 Press the + or - INPUT LEVEL buttons located on the left side panel of the R-09HR to
adjust your level so the meter in the R-09HR display averages between -12 and -6.
Press to start recording.
4
n
5 Press when you're finished.
g
Playing Back a Recording
The R-09HR contains a convenient onboard speaker for playing back your recordings.
Here's how to listen through the speaker to a recording you've just made.
1 Press ; to begin playback.
4/
2 Press the + or – buttons on the side panel to adjust the playback volume.
Tip: To move backward or forward through the recording, press and hold the I 7 or 8 I
button, respectively.
3 When you're finished, press
Tip:
If you prefer, you can listen through headphones instead of the R-09H's speaker by
plugging your headphones into the phones jack on top of the R-09HR.
©2008 Roland Corporation U.S.
R-09HR
.
g
www.RolandUS.com/EDIROL
W A V /MP3 Recorder
Selecting a Recording for Playback
Note: If only one file has been recorded, it's not necessary to perform the following steps in
order to play it back.
Here's how to select a any of your recordings for playback.
To select a file from the main screen:
1 Press I 7 or 8 I to select different files. As you press the buttons, files are selected as
shown at the top of the display.
To select files while from the Finder screen:
1 Press and release the FINDER button.
Press or 4/
2
g
3 Once you've selected the file, press
Selecting the Recording Format
The R-09HR has several different recording formats to choose from. For example, files
recorded at 96kHz/ WAV-24bit mode have better sound quality than files recorded at
44.1k/MP3 192kpbs; however, they use up more memory. Here's how to change the
recording format to suit your needs.
1 Press MENU—"SELECT" flashes in the upper right corner of the display.
2 Press or 4/
g
3 Press .
n
4 Press I 7 or 8 I to choose the desired Sample Rate (44.1, 48, 88.2, or 96.0 kHz ).
Press to select
5
g
6 Press I 7 or 8 I to change the recording mode.
Note: For more details and descriptions of the different modes, refer to Pages 34-35 in the
R-09HR Owner's Manual.
7 Press MENU twice to return to the main screen.
; to choose the desired file.
twice to load it.
n
; to select Recorder Setup.
Rec Mode.
TBS269 1