Connecting The Scxi-1104/C To A Daq Device For Multiplexed Scanning In An Scxi Chassis; Figure 2-1. Installing The Scxi-1104/C Module - National Instruments SCXI-1104 User Manual

1 SCXI Chassis Power Switch
Connecting the SCXI-1104/C to a DAQ Device for Multiplexed Scanning
in an SCXI Chassis
© National Instruments Corporation
®
1
S C
X I
M A
IN
F R
A M
E
2
3
2 SCXI Chassis Slots

Figure 2-1. Installing the SCXI-1104/C Module

To complete your SCXI-1104/C installation, follow the procedure in the
appropriate sections that follow.
This configuration allows you to multiplex all 32 input channels of the
SCXI-1104/C into a single channel of your DAQ device. You need the
following items for this installation:
• SCXI chassis with the SCXI modules installed
• SCXI cable assembly, which consists of a cable adapter and a cable
• An installed National Instruments DAQ device
• 1/4 in. flathead screwdriver
Consult your SCXI chassis documentation, other SCXI module
documentation, and DAQ device documentation for additional instructions
and warnings. Your SCXI-1104/C module and any other SCXI modules
Chapter 2
3 SCXI Module Thumbscrews
2-3
Installation and Configuration
SCXI-1104/C User Manual