Table of Contents
Advertisement
C C . . C C o o n n n n e e c c t t t t h h e e b b a a s s e e u u n n i i t t
1 1 Connect the AC adapter to the D D C C I I N N 9 9 V V jack
and to a standard 120V AC wall outlet.
2 2 Set the base unit on a desk or tabletop and
place the handset on the base unit as shown.
3 3 Then raise the antenna to a ver tical position.
Af ter installing the batter y pack in the
handset, charge your handset at least 1 1 5 5 - - 2 2 0 0
h h o o u u r r s s b b e e f f o o r r e e p p l l u u g g g g i i n n g g i i n n t t o o t t h h e e p p h h o o n n e e l l i i n n e e .
Once the handset batter y pack is fully
charged, connect the telephone line cord
to the base and telephone wall outlet.
4 4 Connect the telephone line cord to the T T E E L L L L I I N N E E jack and to a
telephone outlet.
If your telephone outlet isn´t modular, contact
your telephone company for assistance.
D D . . C C h h o o o o s s e e t t h h e e d d i i a a l l i i n n g g m m o o d d e e
Depending on your dialing system, set the P P U U L L S S E E - - T T O O N N E E switch as follows:
I I f f y y o o u u r r d d i i a a l l i i n n g g s s y y s s t t e e m m i i s s
Tone
Pulse
If you aren´t sure of your dialing system, make a trial call with the P P U U L L S S E E - - T T O O N N E E
switch set to T T O O N N E E . If the call connects, leave the switch as is; otherwise, set to
P P U U L L S S E E .
M M o o d d u u l l a a r r
S S e e t t t t h h e e s s w w i i t t c c h h t t o o
T T O O N N E E
P P U U L L S S E E
• Place the power cord so
it does not create a trip
hazard or where it could
become chafed and
create a fire or electrical
hazard.
• Use only the supplied
AD-312 AC adapter. Do
not use any other AC
adapter.
• Connect the AC adapter
to a continuous power
supply.
• Place the base unit close
to the AC outlet so that
you can unplug the AC
adapter easily.
G E T T I N G S T A R T E D
[ 11 ]
Advertisement
Table of Contents
