Lane Keep Assist - Vauxhall CORSA Owner's Manual

166 Driving and operating

Lane keep assist

Lane keep assist supports the driver
to avoid unintended leaving of the
lane. The front camera observes road
edges, as well as the lane markings
between which the vehicle is driving.
If the vehicle approaches a road edge
or a lane marking, the steering wheel
is gently turned to position so that the
vehicle turns back into the lane. The
driver will then notice a turning
movement of the steering wheel. Turn
steering wheel in same direction, if
the system does not steer sufficiently.
Turn steering wheel gently into
opposite direction, if lane change is
intended.
When the system steers to correct the
trajectory of the vehicle, L flashes
yellow in the instrument cluster.
Unintended lane departure is not
assumed by the system when the turn
lights are operated and during few
seconds after turn lights have been
switched off.
If the system detects that the steering
wheel is not held permanently, it
interrupts the correction. A warning
message in the Driver Information
Centre accompanied by a warning
chime alerts when immediate driver´s
action is required.
If the vehicle is equipped with active
side blind spot detection, the
interruption of the lane correction
might be cancelled.
Side blind spot alert 3 159.
Notice
The system may be switched off if it
detects lanes which are too narrow,
too wide or too curved.
Following preconditions have to be
fulfilled:
● vehicle speed must be between
40 mph and 112 mph
● the driver must hold the steering
wheel
● the turn lights are not activated
● the electronic stability control is
activated and not in operation
● the vehicle is not connected to a
trailer or a bicycle carrier
● normal driving behaviour (system
detects dynamic driving style, i.e.
pressure on the brake or
accelerator pedal)
● roads with good lane markings
● no spare wheel is used
● the vehicle is not driven in a tight
corner
Activation
If the system is activated, the LED in
the button j is not illuminated. To
activate the system when the system
is deactivated, press j.