Setting The Pulse/Tone Switch; Automatic Digital Code Security - Uniden EXAI 918 Operating Manual

If the Battery icon begins to flash, the phone is
programmed to eliminate its functions to save
power. The table below describes what to do to
return your phone to normal operation.
During A Call
Handset continues
normal operation.
The Handset beeps and
the battery icon flashes
once every 3 seconds.
Complete your call as
quickly as possible.
Return the Handset to
the Base Unit for
charging.
Note: Allow 15 to 20 hours without any interruption
for the Handset to fully recharge.
Battery Memory Effect
Rechargeable batteries can develop a "memory
effect." This memory effect can reduce talk and
standby time.
To Avoid this Memory Effect
Use the phone until the "Battery Low" indicator
appears. Then, charge the battery for 15 to 20 hours.

Setting the Pulse/Tone Switch

Be sure the PULSE/TONE switch is in the TONE
position.
Note: Most phone systems are Tone dialing.
Check with your local phone company if you
are not sure whether your system is Tone or
Pulse dialing.
EXAI918
In Standby Mode
None of the buttons will
operate.
The Handset battery
icon flashes once every
3 seconds.
You will not be able to
make a call.
Return the Handset to
the Base Unit for
charging.
Automatic Digital Code
Security
To avoid unauthorized calls on your phone, a
Digital Code feature was added to all EXAI918
phones. This Digital Code is shared only between
the Handset and Base Unit. The code is set
automatically when you first use the phone.
To change or reset the Digital Code, be sure the
Handset is on the Base Unit, then:
1. Press page/find on
the Base Unit.
2. After the Handset
stops beeping,
remove it from the
Base Unit.
3. Wait 5 seconds
then place the
Handset on the
Base Unit.
4. The Status icon on
the Base Unit will
blink to indicate that
the Digital Security
Code is set to one
of the more than
65,000 codes.
15