Factory-Default Settings; Access The Nfx350 Device - Juniper NFX350 Quick Start Manual

Factory-Default Settings

The NFX350 device is shipped with the following factory-default settings:
Table 1: Security Policies
Source Zone
trust
trust
Table 2: Interfaces
Port Label Interface
0/0 to 0/7 ge-0/0/0 to ge-0/0/7
0/8 to 0/15 xe-0/0/8 to
xe-0/0/15
MGMT fxp0
Table 3: LTE Interfaces
Interface
cl-1/1/0
dl0 (logical)
The NFX350 device is shipped with the following services enabled by default: DHCP, HTTPS, and TFTP.
To provide secure traffic, a basic set of screens are configured on the untrust zone.

Access the NFX350 Device

1. Ensure that the NFX350 device is powered on.
2. Connect to the console port:
a. Plug one end of the Ethernet cable into the console port on your NFX350 device.
b. Connect the other end of the Ethernet cable to the RJ-45—to—DB-9 serial port adapter shipped with your device.
Destination Zone
trust
untrust
Security Zone
trust
untrust
N/A
Security Zone
N/A
untrust
Policy Action
permit
permit
DHCP State IP Address
server 192.168.2.1/24
client ISP assigned
N/A 192.168.1.1/24
IP Address
N/A
ISP assigned
7