Installing Your Phone; Charge The Battery - Uniden DECT2180 Series User Manual

Charge the Battery

1) Unpack all handsets, battery packs, and
battery covers. If any battery cover is
already on the handset, press in on the
notch and slide the cover down and off.
Black Black
4) Place the cover over the battery
compartment and slide it up into place.
5) Connect the base AC adapter to the
jack on the rear of the base. Route
7.8V
the cord through the molded wiring
channel as shown.
6) If you have accessory
handsets, connect a
charger AC adapter to
each charger's
jack and set the plug
into the notch as
shown. (These
adapters might already
be connected.)

Installing Your Phone

Red Red
AC IN 8V
V V
A C I N 8 A C I N 8
7)
2) Line up the red and black wires
on the battery pack with the
label inside the handset.
3) Push the connector in until it
clicks into place; tug gently
on the wires to make sure
the battery pack is securely
connected.
AC IN
Plug the other end of each adapter into
a standard 120V AC power outlet.